EasyManuals Logo

Go Power GP-PWM-30 User Manual

Go Power GP-PWM-30
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background image
Solar Controller
GP-PWM-30
______________________________________________________________________
13
© 2012 Carmanah Technologies Corporation
September 2012
Viewing the Controller
display information
To toggle between State of
Charge (SOC), Battery
Voltage and PV Charging
Current, press the B Button.
The battery state of charge is
shown as a percentage.
Icons Displayed: Battery,
Percent Symbol
Push the B Button to show
the battery voltage.
Icons Displayed: Battery,
Volt Symbol (V)
Push the B Button to show
the PV charging current. The
GP-PWM-30 will begin to limit the current as the battery reaches a full
charge.
Icons Displayed: Sun, Battery, Current Symbol (A)
NOTE:
Non-volatile memory: Any settings made on the GP-PWM-30 will be
saved even when the power has been disconnected from the controller.

Other manuals for Go Power GP-PWM-30

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Go Power GP-PWM-30 and is the answer not in the manual?

Go Power GP-PWM-30 Specifications

General IconGeneral
Input Voltage12 VDC
Max Input Current30A
EfficiencyUp to 99%
Battery TypesAGM, Flooded, Lithium, Gel
Protection FeaturesReverse Polarity, Short Circuit

Related product manuals