To Next Page

To Previous Page

[page 16] | gpelectric.com

6. OPERATION AND DISPLAY

6.1.1 LCD MAIN INTERFACE

6.1.2 NAVIGATION BUTTONS

The remote features 4 buttons which, from left to right, are:

They equal to (“Up”, “Down”, “ESC”, “Set”)

Button OPERATION DISCRIPTION

Tap, press and

hold

1) When browsing a menu , tap the button to page up,

2) In parameter setting, tap the button to increase the value by a minimum unit;

3) Press and hold the button for quick page-up to quickly increase a value.

Tap, press and

hold

1) When browsing a menu, tap the button to page down;

2) In parameter setting, tap the button to decrease the value;

3) Press and hold the button for quick page-down to quickly increase a value

Tap

1) When browsing a menu, tap the button to return to the previous level, until the

main menu is reached;

2) In setting mode, tapping this button can cancel the data modication in process

and exit the setting mode.

Press and hold

In any menu, press and hold the button to immediately skip to the “error code

page for convenience.

Tap

1) In a menu which contains submenus, tap the button to enter into a submenu;

2) In a menu with settable or adjustable parameters, tap the button to enter into or

conrm a parameter setting.

Press and hold

If “manual mode” is selected as the load mode, press-and-hold on the button to

switch on/ o󰀨 the load

If it’s not in the manual mode, press-and-hold will cause the display to skip to the

load mode setting interface as a reminder.

(Note: if no load is connected to the controller, this function and related load

parameters will become inoperative.)

Go Power MPPT-PRO Series User Manual

Questions and Answers: