Gocycle
®
Owner’s Manual for GX, April 2019
© Karbon Kinetics Limited. All Rights Reserved. 116
Using two 14mm cone
adjustment spanners, adjust the
rear hub gear bearing cone.
Between adjustments, check
that the rear hub rotates in the
freewheel direction. The bearing
cup nuts should be tightened
until the wheel does not have
more than 1mm of “free” play at
the rim, and the wheel is able to
rotate freely. This is a matter of
compromise and feel. If in
doubt, consult your local
Gocycle dealer or
Gocycle Tech
Support for advice.
Retighten the outer lock nut.
Note: after tightening the outer
lock nut, the hub may need re-
adjusting due to the nature of
the tightening process. You may
need to repeat this process until
you have the desired freeness
of rotation and minimal lateral
play at the rim.
First, loosen the
lock nut.
Second, tighten the
inner adjuster nut.
Retighten the
outer lock nut
Hold the inner nut
stationary
To Next Page