Gocycle
®
Owner’s Manual for GX, April 2019
© Karbon Kinetics Limited. All Rights Reserved. 90
be completed as part of your regular maintenance to reduce the likelihood of developing noises when
riding.
As part of regular maintenance or in the event that your Gocycle Lockshock™ develops a noise whilst
riding, the Lockshock™ can be lubricated using a suitable silicone lubricant. With the Gocycle
supported, remove the Fold Strap Assembly and rotate the Lockshock™ so that it is pointing
upwards. Be sure to have a cloth ready to remove any excess silicone lubricant.
Spray a generous amount of silicone lubricant down into the end of the Lockshock™ and remove any
overspray or spillages with a cloth. Wait 5 minutes with the Lockshock™ in the upright position so that
the lubricant can disperse downwards. Re-insert the Lockshock plunger and Fold Strap Assembly to
complete.
11.6 Adjusting the Shifting
From time to time, the shifting cable could stretch which might result in your gear shifting not being
accurate. Adjust the shifting as follows:
Rotate the gear shift cable
adjuster barrel clockwise or
anti-clockwise to adjust the gear
shift cable. Rotate clockwise
(loosens the cable) if your gear
selection is placing the Gocycle
is in a gear higher than you
select, and anti-clockwise
(tightens the cable) if your gear
selection is placing the Gocycle
in a gear lower than you select.
Ensure this
part does
not rotate.
To Next Page
Loading...