EasyManua.ls Logo

Gocycle GX - Charging Your Gocycle; How to Charge the Gocycle

Gocycle GX
117 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Gocycle
®
Owner’s Manual for GX, April 2019
© Karbon Kinetics Limited. All Rights Reserved. 19
3.6 Riding in Low Light Conditions
In low light conditions at night, dawn, dusk or during adverse weather conditions such as fog, the
visibility of cyclists is dramatically reduced.
WARNING! Never ride a bicycle in low light conditions without appropriate front and rear lights fitted
and “on” (illuminated) that meet or exceed the national standards of the country in which it is being
ridden.
We recommend that you consult the relevant national safety organization or a reputable cycle dealer
on what the minimum recommended lighting requirements are in your particular country or region.
For reference when selecting lights, your Gocycle has a 34.9mm diameter seat
post and a 38.5 mm diameter upper handlebar stem. We recommend that you
choose a light with a variable length strap mounting system.
The following are additional recommendations:
Wear bright, reflective clothing such as reflective vests, leg and arm bands.
Ensure that your Gocycle is equipped with correctly positioned reflectors (see 4.5
Front and Rear Reflectors).
4 CHARGING YOUR GOCYCLE
4.1 How to Charge your Gocycle
1. Ensure that your Gocycle is not wet. If it is, wipe down with a cloth or wait until it is dry.
2. Plug the charger into the wall main power socket. Switch on the wall mains power.
3. Open the rubber charging port cover.
4. Insert the charging lead into the charging point of the battery.
5. The charger light will turn orange to indicate charging. Charge time up to 7 hours with
Gocycle 2amp charger. For faster charging times the Gocycle Fast Charger is available. Visit
www.gocycle.com for more information.
6. When the battery is fully charged (5 LEDs showing on the dashboard display or 100% on the
GocycleConnect App or 4 LEDs on the battery), remove the charging lead and replace the
rubber charging port cover.
BEST PRACTICE! With the battery fully charged and the charger disconnected, turn the battery off. In
any event, do not leave the Gocycle plugged in to the charger or on charge continuously for more
than 24 hours.

Table of Contents