Godox AD300Pro - Device Protections and Data; Technical Data

25
Other Protections
The system provides real-time protection to secure the deice and your safety. The
following lists prompts for your reference:
Prompts on
LCD Panel
Meaning
E1
A failure occurs on the recycling system so that the flash cannot fire.
Please restart the flash unit. If the problem still exists, please send
this product to a maintenance centre.
E2
The system gets excessive heat. Please allow a rest time of 10
minutes.
E3
The voltage on two outlets of the flash tube is too high. Please send
this product to a maintenance centre.
E9
There are some errors occurred during the upgrading process.
Please using the correct firmware upgrade method.
Technical Data
Model
AD300Pro
Wireless Slave Unit Mode
Radio transmission mode (compatible
with Nikon & Canon & Sonya & Fujifilm &
Olympus & Panasonic & Pentax)
Flash Mode
Wireless off
Slave unit of radio transmission
M/Multi
TTL/M/Multi
Compatible Cameras under Radios
Transmission (as slave unit)
Nikon cameras (X1T-N as master unit.)
Canon EOS cameras (X1T-C as master
unit)
Sony cameras (X1T-S as master unit)
Fuji cameras (X1T-F as master unit)
Olympus cameras (X1T-O as master unit)
Flash Duration t.01 (approx.)
1/220 to 1/10200 seconds
Power
300W
Power Output
9 steps: 1/256~1/1
Stroboscopic Flash
Provided (up to 90 times, 99Hz)
Flash Exposure Compensation (FEC)
Adjust the parameters in the 2.4G remote
control
Sync mode
High-speed sync (up to 1/8000 seconds),
first-curtain sync, and second-curtain sync
Delay Flash
0.01-30 seconds
Mask
Beeper