3. Press <SET > button again to confirm the setting.
FEB: Flash Exposure Bracketing
You can take three flash shots while automatically changing the flash output for each shot from
-3 to +3 in 1/3rd stops. The camera will record three images with different exposures: one
exposed according to camera calculations, one over-exposed and another under-exposed. Over
and under exposure amount is user adjustable. This function helps get correct exposure
especially in shooting moving objects or when environmental lights are complex.
1. Press function button 3 < >. The icon < > and the exposure bracketing amount
will be highlighted on the LCD panel.
2. Set the exposure bracketing amount.
● Turn the Select Dial to set the amount.
● “0.3”means 1/3 step, “0.7”means 2/3 step.
3. Press <SET> button again to confirm the setting. Then the FEC and FEB settings are
displayed on the LCD panel.
FEL: Flash Exposure Lock
FEL can lock the correct flash exposure setting for any part of the scene.
With <ETTL> displayed on the LCD panel, press the camera’s <FEL> button. If the camera does
not have the <FEL> button, press the < > button.
1. Focus the subject.
z FEB will be cancelled after three photos are taken.
z For best results, set the camera drive mode to “single” and ensure the flash is ready before
shooting.
z FEB can be used with FEC and FEL.
You can prevent the FEB from being cancelled automatically after three photos are taken. (C.Fn-FEB
ACL)
The FEB shooting sequence can be changed. (C.Fn-FEB)
To Next Page
Loading...
