Godox Xpro C - Custom Function (C.Fn) Settings

18
C.Fn: Setting Custom Functions
The following table lists the available and unavailable custom functions of this flash.
Custom
Function
Function
Setting Signs
Settings and Description
STBY
Sleep
ON
ON
OFF
OFF
BEEP
Beeper
ON
ON
OFF
OFF
STEP
Power output
value
1/128
The minimum output is 1/128 (change in 0.3
step)
1/256
The minimum output is 1/256 (change in 0.3
step)
1/128(0.1)
The minimum output is 1/128 (change in 0.1
step)
1/256(0.1)
The minimum output is 1/256 (change in 0.1
step)
LIGHT
Backlighting
time
12 sec
Off in 12 seconds
OFF
Always off
ON
Always lighting
SYNC
Sync cord jack
IN
Enable XProC to trigger flash
OUT
Export triggering signal to trigger other remote
control and flash
GROUP
Group
5 (A-E)
5 groups (A-E)
16 (O-F)
16 groups (0-F); 16 groups when the receiver
end is studio flash, which can only be set to M
mode in this state.
LCD
Contrast ratio
of LCD panel
-3-+3
The contrast ratio can be set as integral
number from -3 to +3
SHOOT
One-shoot
Only send triggering signals in the M & Multi
mode when camera is shooting
Full-shoot
Send parameters and triggering signal when
camera is shooting (suitable for multiple person
photography)
APP
APP
Only send triggering signal when camera is
shooting (control the flash’s parameters by
smartphone APP)
DIST
Triggering
distance
0-30m
0-30m triggering
1-100m
1-100m triggering
ID
Wireless ID
OFF
Off
01-99
Choose any figure from 01-99 (the current
version flashes cannot use this function
temporarily)
TCM
TCM Transform
function
TT685/V860II series
The power output
values in the M mode
which are transformed
from TTL mode, begin
subjected to the master
flash when mixing.
200j
AD200
360j
600j
AD360II
AD600