EN
FM RADIO
FM radio mode receives analog radio from the FM band and displays RDS (Radio Data System)
information about the station and where broadcast.
Scanning for stations
• Press the VOLUME/OK/SCAN knob on the device to search for the next station.
• Press repeatedly the / button on the remote control to set desired station/frequency. Press
and hold the same button to search for the previous/next station.
Settings menu
[Scan settings] > By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings to stop only at stations
with good signal strength, select [YES] after choosing [Strong station only?].
[Audio settings] > All stereo stations are reproduced in stereo. For weak stations, this may result
in a poor signal-to-noise ratio (hiss). To play weak stations in mono, select [YES] after choosing
[Listen in mono only?].
BLUETOOTH
Pair your phone with the device before listening to music. If the device is not paired with any
phone, the icon will ash at the bottom display. Activate Bluetooth of mobile phone and search
for device name “IR 237 BTDAB” then connect it.
NOTE: If you are asked to enter a passcode, enter 0000.
If the pairing is successful, the icon will be solid and you can use the device to listen to music
from your mobile phone.
NOTE: The operational range between the unit and the device is approximately 8 meters. If the signal strength is
weak, your Bluetooth receiver may disconnect, but it will re-enter pairing mode automatically. For better signal
reception, remove any obstacles between the unit and the Bluetooth device.
Compatibility with all devices and media types is not guaranteed.
Some mobile phones with Bluetooth functions may connect and disconnect as you make and end calls. This is not
an indication of a problem with your unit.
Disconnecting the paired mobile phone
To disconnect your phone from the device, press and hold PRESET/PAIR button.
ALARM
There are two wake-up alarms with a snooze facility. Each alarm can be set to start in a particular
mode.
Select [Alarms] under the [Main menu] to set or change an alarm. After setup all the parameters,
select [Save] to activate.
NOTE: When the alarm is set, it shows the [ ] and/or [ ] icon at the bottom of the display.
At the set time, the alarm will sound:
• Press the button on the device or on the remote control to turn off the alarm.
• To temporarily silence, press the SNOOZE button on the remote control. You can set the snooze
period (5, 10, 15, 30 min.). The radio returns to standby for the set period, with the alarm icon
flashing.
To Next Page
