IM067B2 – June 2010
5
2. INSTALLATION INSTRUCTIONS
Follow these instructions carefully.
1. Have a licensed gas fitter or our local gas company connect the appliance to the
mains pressure supply. The gas inlet connection can be seen in the appendix on
Page 11. The appliance must be installed in accordance with rules of any
authority having jurisdiction as per below. The regulator is built into the gas
control, behind side panel on Page 11.
NOTE: The appliance must be installed by an authorised Gas Fitter and in
accordance with the regulations of the local Gas Authority, AS5601/AG601
and any other authority having jurisdiction. The appliance has been tested
and preset before leaving our factory, but small adjustments may be
necessary to suit local conditions. Correct operation of the appliance must
be tested as part of the installation procedure. Check Page 7
Commissioning.
Licensed Gas Fitter should make connection to main gas line. Install a hand
shut-off valve in gas line to the appliance manifold.
As from 1
st
January 2005. The new AGA AS4563/AG300 codes states that all L.P.G.
appliance will be supplied with a separate regulator for each appliance.
NOTICE
PLEASE RETURN YOUR WARRANTY CARD
FAILURE TO DO SO WILL VOID
WARRANTY ON THE EQUIPMENT
To Next Page
Loading...