rogramming the telephones.
P
For T-940 Uno and T-740 Uno telephones:
107
TELEPHONES PROGRAMMING
To program the telephone as master,
hang up the handset.
To program it as slave, press the door
release push button.
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
Enter the code that will be used to call to
this telephone and press the key.
At this moment the panel and the telephone
handset will reproduce a sound.
To show that the system is ready for programming, the panel
will reproduce a sound and the LCD will display the
message program mode. At this moment, the door
release push button can be released. Audio communication
with the door panel is enabled.
Press the door release pushbutton and with this button
pressed, pick up the handset.
Make a call to make sure that the telephone has been properly programmed.
Program the other telephones in the same way.
At the end of the program process, exit the configuration menu by pressing
The key. If you forget to do this, the doorpanel will exit
automatically the menu after 90 seconds.
For all the telephones:
108
FINAL ADJUSTMENTS
inal adjustments.
F
lose the door panel.
C
IMPORTANT: Keep the screwdriver bit in a safe place for later manipulations of the door
Panel.
If after starting the system it's considered that the
audio volume isn't correct, proceed with the
necessary adjustments as shown.
The telecamera has a pan and tilt mechanism
built in to adjust the telecamera position.
Fix the door panel with the supplied antivandal screws. Use the screwdriver bit for 1/4”
(also supplied).
Door panel 1 module Door panel 2 modules
NOTE: If there is an informative module, the labels are available in the web "www.golmar.es"
section services.
To Next Page
Loading...
