Goodman Amana AMES800604BUAA - System Operation; System Operation Safety

SYSTEM OPERATION
6

Please adhere to the following warnings and cautions when
installing, adjusting, altering, servicing, or operating the
furnace.

 R RS JR R    RR S
JS R SR R  RR  S


R  SSS R R S 
Q SR SR  R  S SR



 R SS RR  RS JR R 
  R SK  R S    R
 R S R R

Discharge your body’s static electricity before
touching unit. An electrostatic discharge can adversely
a󰀨ect electrical components.
Use the following precautions during furnace installation
and servicing to protect the integrated control module from
damage. By putting the furnace, the control, and the per-
son at the same electrostatic potential, these steps will help
avoid exposing the integrated control module to electrostat-
ic discharge. This procedure is applicable to both installed
and uninstalled (ungrounded) furnaces.
1. Disconnect all power to the furnace. Do not touch the
integrated control module or any wire connected to
the control prior to discharging your body’s electro-
static charge to ground.
2. Firmly touch a clean, unpainted, metal surface of the
furnace near the control. Any tools held in a person’s
hand during grounding will be discharged.
3. Service integrated control module or connecting
wiring following the discharge process in Step 2. Use
caution not to recharge your body with static electrici-
ty; (i.e., do not move or shu󰀪e your feet, do not touch
ungrounded objects, etc.). If you come in contact with
an ungrounded object, repeat Step 2 before touching
control or wires.
4. Discharge any static electricity from your body to
ground before removing a new control from its
container. Follow Steps 1 through 3 if installing the
control on a furnace. Return any old or new controls
to their containers before touching any ungrounded
object.

This product is designed for NATURAL GAS ONLY. This
product is designed for use as a residential home gas fur-
nace. It is  designed or certied for use in mobile home,
trailer, or recreational vehicle applications.





To ensure proper installation, operation and servicing, thor-
oughly read the installation and service manuals for specif-
ics pertaining to the installation, servicing and application of
this product.


SS RR  RS JR R    R
XS SK S S R SK R R
X  RS R RR S RR R
R   S R


 R RR  RS JR R    R
  S S R     RR R RR

To ensure proper furnace operation, install, operate,
maintain and service the furnace in accordance with the
installation, operation and service instructions, all local
building codes and ordinances. In their absence, follow
the latest edition of the National Fuel Gas Code (NFPA 54/
ANSI Z223.1), and/or CAN/CGA B149 Installation Codes,
local plumbing or waste water codes, and other applicable
codes.
The rated heating capacity of the furnace should be greater
than or equal to the total heat loss of the area to be heated.
The total heat loss should be calculated by an approved
method or in accordance with “ASHRAE Guide” or “Man-
ual J-Load Calculations” published by the Air Conditioning
Contractors of America.


    R S R S 
R  SS  S  S  R  SSR 
S RR S

KS    SS  RS  SRS
RS JR R    XSR   RS
 R X

The furnace rating plate includes the approved furnace gas
input rating and gas types. The furnace must be equipped
to operate on the type of gas applied. This includes any
conversion kits required for alternate fuels and/or high
altitude.