Goodman GPH1360M41 User Manual

C
US
®
*NOTE: Please contact your distributor or our
website for the applicable Specification Sheets
referred to in this manual.
RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION.
ATTENTION INSTALLING PERSONNEL
Prior to installation, thoroughly familiarize yourself with this Installation Manual. Observe all safety warnings. During
installation or repair, caution is to be observed.
It is your responsibility to install the product safely and to educate the customer on its safe use.
These installation instructions cover the outdoor
installation of self contained package air conditioners
and heating units. See the Specification Sheets
applicable to your model for information regarding
accessories.
Goodman Manufacturing Company, L.P.
5151 San Felipe, Suite 500, Houston, TX 77056
www.goodmanmfg.com www.amana-hac.com
© 2010-2011 Goodman Manufacturing Company, L.P.
I NSTALLATION I NSTRUCTIONS
F OR S ELF -C ONTAINED P ACKAGE
A IR C ONDITIONERS AND H EAT P UMP U NITS
GPC/GPH 13 SEER “M” SERIES
W
ITH R-410A
IO-395B
9/2011
is a registered trademark of Maytag Corporation or its related companies and is used under
license to Goodman Company, L.P., Houston, TX. All rights reserved.

Goodman GPH1360M41 Specifications

General

Brand	Goodman
Model	GPH1360M41
Category	Air Conditioner
Language	English

Summary

To The Installer

Safety Instructions

General Safety Warnings

Critical warnings including high voltage, device compatibility, chemical hazards, water submersion, construction use, and flammables.

Codes and Regulations

Pre-Installation Checks

Clearances and Accessibility

Ground Level Foundation

Rooftop Installation Prep

Rigging Details

Filters

Ductwork

Wiring Procedures

High Voltage Wiring

Specifics on connecting single-phase and three-phase high voltage wiring.

Low Voltage Wiring

Instructions for connecting thermostat wires for AC and heat pump units.

Internal Wiring Guidance

Startup, Adjustments, and Checks

Unit Start-Up Checklist

Step-by-step guide for the initial startup of the unit in cooling mode.

Heat Pump Start-Up

Specific startup procedures for heat pump operation in cooling and heating modes.

Final System Checks

Essential checks to ensure proper operation and balance after startup.

Unit Components

Defrost Control

How the defrost control initiates, terminates, and manages defrost cycles.

Outdoor Thermostat

Reversing Valve Coil

Indoor Blower Motor

Heat Pump Operation

Cooling Cycle Operation

Heating Cycle Operation

Defrost Control

Suggested Field Testing/Trouble Shooting

Airflow Measurement and Adjustment

Speed Tap Adjustments

Refrigerant Charge Checks

System Superheat Calculation

Formula and steps to calculate system superheat for proper refrigerant charge.

Electrical Adjustments

Maintenance & Service

Heat Pump Heating Performance Issues

Common causes for unsatisfactory heat pump performance during the heating cycle, including airflow, refrigerant charge, and valve issues.

Troubleshooting Chart

Minimum Clearances