This product is designed and manufactured to permit
installer’s responsibility to install the product in accordance
The unit includes a hermetically sealed refrigerating system
(consisting of a compressor, condenser coil, evaporator
includes a reversing valve, solenoid, defrost thermostat
INSTALLATION
should be considered:
•
• Clearances and provision for servicing
•
• Air duct connections
• Drain facilities and connections
• Location may be on any four sides of a home,
manufactured or modular, to minimize noise
The unit is designed to be located outside the building
Additionally, the unit must be situated to permit access
spaces, such as corners provide a minimum 12” clearance
be located under an overhang, there should be a minimum
recommended that the unit be placed so that condenser air
The unit should be set on a solid, level foundation –
slab should be above ground level and surrounded by
unit’s foundation should not adjoin the building as it is
possible that sound and vibration may be transmitted to
bases have holes under the outdoor coil to permit drainage
To Next Page
Loading...
Need help?
General