The condensate drain connection of the evaporator is a
2" Minimum
3" Minimum
A Positive Liquid Seal
Is Required
Flexible
Tubing-Hose
Or Pipe
Drain
Connection
Unit
CAUTION
Install a branch circuit fused disconnect near the unit, in
overcurrent protection should be determined from the unit
be sized smaller than is recommended by either of these
nameplate could result in unnecessary fuse failure or
damage caused to equipment as result of the use of larger
All units have undergone a run test prior to packaging for
The units are designed for operation at the voltage,
in
CAUTION
20 30
3 3 2 2
3 3
10
12 10 10
To Next Page
Loading...
Need help?
General