DAB operation (contd.)
Factory Defaults
This feature allows the unit to be reset to the state it was when it was first manufactured. It clears all memories,
including all presets and the Station List.
Selecting Factory Defaults
Press the “ Menu” button and then use the “Up” and “Down” buttons to move to
the Set Defaults function. Press the “Selects” button to enter the Set
Default function.
To proceed with set defaults, press the “Select” button briefly.
This message confirms that all presets are being cleared, and all “service” lists
are being erased.
AFTER ABOUT 10 SECONDS an Autotune operation will then start automatically.
SLEEP TIMER
This function enables the system to automatically power down after a preset SLEEP time has
elapsed
To Set a sleep time
Press the SLEEP button “Sleep Time “ and
00:30
will show in the display
Using the UP and DOWN buttons adjust the desired sleep time between 10 minutes and 1 hour
30 minutes, the minimum sleep time setting is 10 minutes.
Press the select button to set the sleep time an animated clock symbol
will appear in the
bottom right hand corner of the display indicating the sleep function is running.
After the preset time is reached the unit will switch to standby.
IMPORTANT NOTE : Pressing the SLEEP button whilst the SLEEP function is active will result in
the sleep countdown being reset to the pre selected sleep time, it is not possible to display the
remaining sleep time.Using the sleep function after initial use will revert the sleep time to the last
time set , i.e. if 10 minutes was used previously then the display will show
00:10
when the
sleep button is pressed.
To switch the unit on after using the SLEEP function press the Standby/ON buttton on the remote
control.
Goodmans Product Information Helpline 0870 873 0080
17
To Next Page
Loading...
