Goodview M Series - Troubleshooting

26
According to the prompt, it will automatically playback the program once the
USB removed. (Note: Name the program as 1,2,3 if you want to play in order)
V.Troubleshooting
Problem
Reason
Solution
1.The power cord is
d
isconnected 1.Plug in the power cord.
2.The power switch (on the
back of the machine) is off.
2.Make sure the power
switch is on.
No image
3.Network is not connected.
3.Connect the signal to
the display.
4.The display is in standby
mode.
U
nstable display or
with noise
Caused by surrounding
electrical equipment or
fluorescent lights.
M
ove the machine to the
other place to check again
1
.The signal cord is not
properly connected.
1.Ensure the signal cord
is well connected
Image is unfocussed
2.Wrong signal input.
2.Check if the signal
spec is allowed
Abnormal color
The signal cord is not properly
connected
Ensure the signal cord is
well connected
Please make sure the
v
ideo input and audio
input are well connected.
With sound but not
image
Misconnect of the signal cords.
1.Make sure the audio
input is well connected.
1.Misconnect of the signal
cords.
2.Press the [VOLUP]