Why is my Goodwe Inverter showing 'PV Over Voltage'?
If your Goodwe Inverter displays 'PV Over Voltage', it means that too many PV modules are connected in series, causing the open-circuit voltage to exceed the operating voltage. Check whether the PV string input voltage is consistent with the value displayed on the LCD and meets the maximum input voltage requirements.
What causes 'Fac Fail' on a Goodwe Inverter?
If your Goodwe Inverter shows 'Fac Fail', it indicates that the utility grid frequency is out of the allowed range. Check whether other electrical devices under the same grid connection point is working normally, and whether the main supply is normal. Ensure the grid frequency is within the allowed range and that the phase sequence of the AC cables are connected correctly, and the neutral wire and PE cable are properly and firmly. If the fault happens occasionally, it may be due to instantaneous utility grid frequency change and does not need to be handled.
What does 'Vac Fail' mean on my Goodwe GW10KT-DT?
If your Goodwe Inverter shows 'Vac Fail', it means the utility grid voltage is out of the allowed range. Make sure that the grid voltage is within the allowed range. Also, ensure that the phase sequence of the AC cables are connected correctly, and the neutral wire and PE cable are properly and firmly.
What to do if my Goodwe GW10KT-DT displays 'Isolation Fail'?
If your Goodwe Inverter is showing an 'Isolation Fail' error, it could be due to: 1. A short circuit to the ground in the PV system. Check the PV input cables for any breaks. 2. A moist environment affecting the PV system's insulation. Ensure the module frames and metal bracket are securely grounded. 3. Also, check that the AC side is properly grounded.
How to fix an 'Over Temperature' error on my Goodwe Inverter?
If your Goodwe Inverter is showing an 'Over Temperature' error, there are a few things to check: 1. Ensure that the inverter has adequate ventilation and space for heat dissipation. 2. Verify that the ambient temperature is not too high. 3. Confirm that the fans are working correctly and are not blocked.
Provides general safety guidelines and precautions for using the inverter.
Details safety precautions related to the DC side of the inverter.
Outlines safety precautions for the AC side of the inverter.
Specifies environmental and mounting requirements for inverter installation.
Step-by-step guide for physically mounting the inverter.
Crucial safety warnings before making electrical connections.
Instructions for properly connecting the protective earth (PE) cable.
Details how to connect the DC input cables from the PV array.
Guides on how to connect the AC output cable to the grid.
Procedures and safety warnings for powering down the inverter for maintenance.
General advice and information needed for troubleshooting inverter issues.
To Next Page
General
