Gorgy Timing HANDI - 4 Advanced FEATURES; Configuring Many Clocks; Re-Configure the Clocks; Saving the Configuration (GT Network Manager Mobile)

31
MDE-option_Wi-Fi_horloges_HANDI_LEDI-1103V1.1
4. ADVANCED FEATURES
4.1. CONFIGURING MANY CLOCKS
► Using the tablet + GT Network Manager Mobile: You just have to tap every clock you
want to congure in the list of detected clocks in the “status” tab.
► In the « Deploy tab », tap the « Send this conguration » button to automatically con-
gure all the clocks in the list. If the clocks are not within range (and so not detected),
you can also use their serial number to add them to the list. ( See the « deploy » tab )
► Without the tab (manual settings): repeat all the steps described in 3 for each clock.
4.2. RE-CONFIGURE THE CLOCKS
► Using the tablet + GT Network Manager Mobile: Connect the tablet to the same Wi-Fi
network as the clocks, and use the « Network scan » feature to add them to the list.
► Without the tab (manual settings) : repeat all the steps described in 3.2. for each clock.
4.3. SAVING THE CONFIGURATION (GT NETWORK MANAGER MOBILE)
► In the GT Network Manager Mobile application, it’s possible to save the conguration to
use it back later. Use these buttons:
: Save the conguration
: Load the saved conguration
4.4. ROAMING CONFIGURATION (GT NETWORK MANAGER MOBILE)
► In the GT Network Manager Mobile application, you can check the « loop » checkbox
in the « deploy » tab. The conguration of the clocks will repeat itself until all the clocks
on the list are congured.
This enables the user to deploy a conguration at a large scale (building), just by moving
with the tablet. As soon are the clocks are in range, they are automatically congured.
ENGLISH