Step 44: Climbing Rope
1: Thread one end of the Rope through the hole in the Rock Wall Side Top Panel Board.
2: Tie a secure knot on the inside of the Rock Wall Side Top Panel Board.
3: Thread the other end of the Rope through the hole in the Bottom Rock Wall Board.
Pull the Rope tight and tie a secure knot behind the Bottom Rock Wall Board.
4: Note: you may tie two knots in the Rope to aid in climbing if you wish. Do this before
performing sub step 3.
5: Once the Rope is tied on both ends attempt to wrap the rope around your hand. If
the rope wraps around your hand it is too loose. Untie one end and retie the rope until
you can no longer wrap it around your hand.
Tie a knot behind this
hole in the Rock Wall
Side Top Panel Board.
You may tie two knots
in the Rope to aid in
climbing if you wish.
Page 73
To Next Page
Loading...
