Step 46: Steering Wheel
1: Place the Steering Wheel Insert inside the Steering Wheel.
2: Use the hardware included (one 3/8 x 2-1/2” lag screw and one 3/8” washer) with the
Steering Wheel to mount the Steering Wheel to the end of the Swing Beam. DO NOT
over-tighten the lag screw into the Steering Wheel Insert or the Steering Wheel will not
turn.
3: Place the Steering Wheel Cap over the center of the Steering Wheel and snap into
place.
Steering Wheel
Steering
Wheel
Insert
Included
Hardware
Steering
Wheel
Cap
Page 75
To Next Page
Loading...
