Step 25: Swing Beam Plate
1: Place the Swing Beam Plate on top of the Swing Beam Support, lining up the pilot
holes.
2: Fasten the Swing Beam Plate to the Swing Beam Support on the outside holes using
3/8” x 3-1/2” carriage bolts from the top and 3/8” washers with 3/8” lock nuts on the
bottom. Place bolt caps over exposed threads after securing.
3: Leave the middle hole empty, it will be used later.
3/8” Washer
3/8” Lock Nut
Bolt Cap
3/8” x 3 ½”
Carriage Bolt
Swing Beam Plate
Page 54
To Next Page
Loading...
