Step 24: Swing Beam Support
1. The 4 x 4 x 47-3/8” Swing Beam Support has counter-sunk holes in the center and on
the ends. Install the Swing Beam Support so that the counter-sunk holes on each end
of the beam face out, and the counter-sunk holes in the center face down.
2. Fasten the Swing Beam Support to the rear corner posts using 3/8” x 6-1/2” carriage
bolts and torque washers. Place the carriage bolt into the torque washer, then into the
hole of the corner post and set with a hammer. Use 3/8” lock nuts and 3/8” washers to
secure the Swing Beam Support from the outside. Place bolt caps over the exposed
threads after securing.
Note: There are two mounting positions for the Swing Beam Support. Use the lower
holes in the rear corner posts if your yard is relatively at. Stand with your back against
the rear of the play set. If your yard runs uphill then you should use the upper holes in
the rear corner posts.
3/8” x 6-1/2”
Carriage Bolt
Torque Washer
3/8” Washer
3/8” Lock Nut
Bolt Cap
Counter-sunk holes
face out
Counter-sunk
holes face down
This hole is to be used
only if your yard runs
up-hill. If installing your
play set on relatively
level ground then this
hole will not be used.
4 x 4 x 47-3/8”
Swing Beam Support
Rear of Play set
Page 53
To Next Page
Loading...
