Gosafe G626 - Set Work Mode; 3 Commands for Device Setting; Set User no

Note:
Please memorize your New Password and wait for confirmation SMS for
password modification from device.
Only if this command is sent by user No., the system can process this command.
2.7 Set Work Mode
There are 3 different work modes configurable for device according to user's need: O, S and G
Detailed information on 3 work modes, please go to "Commands for Device Setting" in this User
Manual.
Example:
To set device in G Work Mode, you should send the following SMS command to the SIM card No.:
****,UUM;30M;G;T
Explanation:
****: password
UUM: Command Control Word
G: the Work Mode user wants to configure
T: the type of message
3.Commands for Device Setting
All the commands for device setting in this User Manuel are in the same format:
user password+ command content
The command content is restricted to digits (0-9), English characters (a-z, and/or A-Z) and/or
common punctuations (Please check "Characters for Commands" table in Appendix), beyond which
device cannot recognize. If there is any character device cannot recognize, device will ignore it and
will not give any related warning to user.
All English control words in command could be capital words or lower case words.
3.1Set User No.
Command Format:
**** , UNO ; xxxxxxxxxx
**** , UNO ; +yyxxxxxxxxxx
Explanations:
****: user password (4-digit)
, : command delimiter
UNO: command control word
; : command delimiter
xxxxxxxxxx--telephone No. without country code
+yyxxxxxxxxxx--telephone No. with country code ("+") is country code mark while "yy" is country
code.
You can send SMS command to set or modify user No. through any mobile phone number.