16 GOSSEN METRAWATT GMBH
Menu Flowchart: Starting and Stopping the Ramp Sequence
9 Using the Menus – from the Initial InFO Menu to
Operating Parameters
Menu-driven operation via the initial InFO menu allows the
user to query online help and configure device parameters.
➭ The initial InFO menu is accessed by simultaneously
pressing and holding the ESC|FUNC and ON|OFF keys with
the instrument switched on until “InFO” appears at the
display.
➭ The display can be switched from the main “info” menu
to the other main “set” menu, and back to the “info”
menu by pressing the #" keys.
➭ After accessing the desired main menu, the associated
sub-menus are opened by activating the ↵ key.
➭ The desired parameter is selected by repeatedly pressing
the #" keys.
➭ Acknowledge with the ↵ key in order to change the cor-
responding parameter or parameters.
➭ After the desired digit has been selected with the $ !
keys and the value has been adjusted with the #" keys,
the next digit is accessed with the ↵ key, or the display is
returned to the start menu or switched to the next sub-
menu.
➭ The calibration mode is started by repeatedly pressing
the ESC key until the simulator display appears.
➭ The calibrator is switched off by pressing and holding the
ON|OFF key until the display goes blank.
The following pages include an overview of the menu struc-
ture.
ramp
set start
ramp
ready
05.000
0-20 t2 run
#
"
+
#"
#"
Start must
2x
mA
mA
Start
RAMP ON
SOURCE
#"
Stop sequence: Display: ho (Hold)
Continue sequence: Display: up (up for rising slope)
dn (down for declining slope)
run (run fur sequence dwell time)
sequence.
blink.
ESC
#
"
+
2x
Stop the
ramp sequence.
ESC during the sequence (run or hold):
Return to measuring or calibration function.
ESC when stopped:
Return to sequence.
ramp
stop
↵
ESC
↵
To Next Page
Loading...
