GOSSEN METRAWATT GMBH 19
10 Accessories
Interface adapters BD232 (without memory), in combination with
calibration software METRAwin
90-2, allow for remote con-
trol of the instrument by PC.
USB-HIT Interface Adapter
Alternatively, the METRA HIT28c light can also be con-
nected to the USB interface of a PC via an USB-HIT adapter.
The driver to be installed allocates a virtual COM interface to
the instrument.
A 2x series multimeter which can be optionally embedded in
a calibration system can be connected via another USB-HIT
adapter with a second USB interface at the PC.
Software METRAwin
90-2
This software allows for paperless documentation and man-
agement of calibration results, the creation of calibration pro-
cedures and remote control of the calibrator.
METRA HIT28c light sequence controls can be imple-
mented online, or off-line after downloading complete calibra-
tion procedures.
The following conditions must be fulfilled in order to allow for
use of METRAwin
90-2:
Hardware Requirements
– WINDOWS and IBM compatible PC with at least
a 200 MHz Pentium CPU and 64 MB main memory
– SVGA monitor with a minimum of
800 x 600 pixels
– Hard disk with at least 40 MB free memory
– 3½" floppy disk drive for 1.4 MB floppies
– MICROSOFT compatible mouse
– if you want to print your data, a WINDOWS compatible
printer.
– 1 free serial COM interface for utilizing BD232
or
– 1 USB interface for utilizing USB-HIT
Software Requirements
➭ WINDOWS 95, 98, ME, NT4.0, 2000 or XP
To Next Page
Loading...
