GOSSEN METRAWATT GMBH 25
14 Repair and Replacement Parts Service
DKD Calibration Lab *
and Rental Instrument Service
When you need service, please contact:
GOSSEN METRAWATT GMBH
Service Center
Thomas-Mann-Strasse 20
90471 Nürnberg • Germany
Phone +49-(0)-911-8602-0
Fax +49-(0)-911-8602-253
E-Mail service@gossenmetrawatt.com
This address is only valid in Germany.
Please contact our representatives or subsidiaries for service
in other countries.
* Calibration Laboratory
for Electrical Quantities DKD–K–19701
accredited per DIN EN ISO/IEC 17025
Accredited measured quantities: direct voltage, direct current
values, DC resistance, alternating voltage, alternating current values,
AC active power, AC apparent power, DC power, capacitance and
frequency
Competent Partner
GOSSEN METRAWATT GMBH is certified in accordance with
DIN EN ISO 9001:2000.
Our DKD calibration laboratory is accredited by the Phys-
ikalisch Technische Bundesanstalt (German Federal Institute
of Physics and Metrology) and the Deutscher Kalibrierdienst
(German Calibration Service) in accordance with DIN EN ISO/
IEC 17025 by under registration number DKD–K–19701.
We offer a complete range of expertise in the field of metrol-
ogy: from test reports and proprietary calibration certificates right
on up to DKD calibration certificates.
Our spectrum of offerings is rounded out with free test equip-
ment management.
An on-site DKD calibration station is an integral part of our ser-
vice department. If errors are discovered during calibration,
our specialized personnel are capable of completing repairs
using original replacement parts.
As a full service calibration laboratory, we can calibrate instru-
ments from other manufacturers as well.
DKD Calibration Certificate Reprints
If you order a DKD calibration certificate reprint for your
instrument, please provide us with the reference numbers
indicated in the upper and lower most fields of the calibration
seal. We do not need the instrument’s serial number.
15 Warranty
The warranty period for all measuring and calibration instru-
ments of the METRA HIT series is 3 years from delivery.
A warranty period of 12 months is granted for calibration.
Warranty covers defective material and workmanship, not
including any damage caused by inappropriate use or oper-
ating errors as well as any follow-up costs.
16 Product Support
When you need support, please contact:
GOSSEN METRAWATT GMBH
Product Support Hotline
Phone +49-(0)-911-8602-112
Fax +49-(0)-911-8602-709
E-Mail support@gossenmetrawatt.com
To Next Page
Loading...
