2 GOSSEN METRAWATT GMBH
1Display (LCD)
2 ON|OFF key
! Cursor position to the right
Operating mode menu:
↵ (ENTER) Changeover to sub-menus /
acknowledgement of entries
3 " Increase values
Operating mode menu: Selection of individual menu items
against direction of flow
4 # Decrease values
Operating mode menu: Selection of individual menu items
in direction of flow
5 ESC key for selecting ranges or functions
$ Cursor position to the left
Operating mode menu: Exit menu level and return to a higher level,
exit parameters configuration
without saving data
6 Rotary switch for simulation functions
7 Connector jack for NA5/600 power pack
8 Connector jacks for calibrator output
9 DKD calibration mark, see page 4
Symbols used in the Digital Display
1 Main display with decimal point and polarity display
2 Auxiliary display with decimal point and polarity display
3 : Simulator in continuous operation
4 NUM: Numeric entry of output signal
5 INT: Interval sequence active
6 RAMP:Ramp function active
7 ON: Calibrator output is active
8 Unit of measure (if blinking, refer to chapter 13 on page 24)
9 SOURCE: Current source is active
10 SINK: Current sink is active
11 Ni/Pt1000: Selected temperature sensor
12 TC: Thermocouple
13 : Low battery voltage (< 3.5 V), replace batteries
1
2
3
4
5
6
7
8
No measuring input !
Do not apply interference voltage
except current sink
!
9
1
2
13
6
3
8
4 57
12 11 11 10 9
8
To Next Page
Loading...
