90 Gossen Metrawatt GmbH
19.7
Intelligent Ramp – ta+I
Function
(
PROFITEST MXTRA
only)
Application
The advantage of this measuring function in contrast to individual
measurement of I
N
and t
A
is the simultaneous measurement of
breaking time and breaking current by means of a test current
which is increased in steps, during which the RCD is tripped only
once.
The intelligent ramp is
subdivided into time
segments of 300 ms
each between the initial
current value (35% I
N
)
and the final current
value (130% I
N
). This
results in a gradation for
which each step corre-
sponds to a constant
test current which is
applied for no longer
than 300 ms, assuming
that tripping does not
occur.
And thus both tripping
current and tripping time are measured and displayed. Measured
quantities are acquired with reduced accuracy.
Connection
Set Parameters
Start Touch Voltage Measurement
Start Tripping Test
The measurement sequence can be broke off prematurely at any
time by pressing the ON/START ▼ key.
Measurement Results
Nom. res. current: 10 … 500 mA
Type 1: RCD, SRCD, PRCD …
Nominal current: 6 … 125 A
Type 2: AC , A/F , B
* Type B = AC/DC sensitive
Touch voltage:
< 25 V, < 50 V, < 65 V
To Next Page
Loading...
