Installation Manual
Stationary Trailer Refrigeration Unit
71.01.121 / 00
Page
29
Copyright by GOVI GmbH 2013. The reproduction of this document or any part there of is prohibited! The right is reserved to make technical changes in the course of further development!
1.
Draw a straight line on the front wall of the trailer to mark the high edge of the
template resp. the prepared cardboard.
2.
Verify that the line keeps the right distance from the top and that it is parallel to
the trailer‘s top edge.
3.
Attach the template resp. the cardboard by taping it in position on the straight
line at the front wall of the trailer.
NOTICE
If you are not sure, which tools to use for work on the trailer, contact the pro-
ducer of the wall materials for inquiry.
4.
Cut out the wall opening into the front wall of the trailer according to the tem-
plate resp. the prepared cardboard using an appropriate tool for the materials
of the trailer wall.
5.
Drill the four bore holes into the front wall of the trailer according to the tem-
plate resp. the prepared cardboard using appropriate drill bits for the materials
of the trailer wall.
6.
Debur the edges of the wall opening and the holes with a file to prevent
scratches on the refrigeration unit during the installation process.
501 N. Grandview Avenue #135
Daytona Beach, FL 32118
Email: sales@govitrailerrefrigeration.com
Inc.
govitrailerrefrigeration.com
GOVI Inc.
Inc.
GOVI Inc. (USA)
GOVI GmbH (Germany)
To Next Page
Loading...