32
Overview of gas firing
This is an overview of the process for
igniting the oven.
Ignition Instructions
1) Remove all packaging from inside the
oven mouth, including the blue stone
retention wedges.
2) Do not use door with gas burner.
3) Remove flue cap from the top of the
oven.
4) Burner control in off position.
5) Turn gas cylinder on.
6) Check no gas leaks.
7)Push and turn burner control
anticlockwise. You should hear a clicking.
8)If burner doesn't light turn burner
control off and wait 2 minutes before
repeating.
Check that the gas you are using is
specified on the data plate page.
The gas cylinder used must have a safety
collar to protect the valve assembly. Do
not use a cylinder that is rusty, dented
or has a damaged valve.
We recommend using a 9kg gas bottle
in conjunction with Arc and 5kg as a
minimum.
Connect the regulator to the gas
cylinder, following the instructions for
your regulator accordingly. Do not force
the regulator as this could damage the
gas bottle.
WARNING: If at any point you smell gas:
Shut off the gas from the cylinder,
turn off the switch on Arc and extinguish
any open flames.
If odour continues, move away from Arc
and gas supply then contact your gas
supplier or fire service.
Ensure that the LPG cylinder or regulator
valve is closed.
Do not store a spare LPG cylinder under
or near this appliance.
CONNECTING TO GAS
Arc and Arc XL Technical Document AU.indd 32 07/11/2023 16:28:45
To Next Page
Loading...
