Need help?Do you have a question about the GpsGate GPS1195 and is the answer not in the manual?
Details the wiring pin assignments for the vehicle loop detector.
Provides instructions for cutting slots and installing loop wires using the saw cut method.
Explains the formula and table for calculating the approximate inductance of a loop.
Lists terminal assignments for 120Vac line voltage connections in Connector 1.
Lists terminal assignments for 24Vdc low voltage inputs in Connector 2.
Details the terminal assignments for relay contact outputs in Connector 3.
Outlines terminal assignments for outputs and isolated relays in Connector 4.
Specifies terminal assignments for relay contacts in Connector 5.
Lists terminal assignments for detector loops and 24Vdc supply in Connector 6.
Explains the function of dip switches for loop and operation settings.
Outlines routine monthly checks for the barrier gate, including belts and oil levels.
Details annual maintenance tasks such as oil changes, bolt tightening, and wiring checks.
Provides steps for adjusting the drive belt tension by a qualified technician.
Describes PLC input/output status for vend and reset operations in down position.
Explains behavior of inputs and outputs related to the safety edge function.
Details PLC input/output behavior in auto and manual modes for arm movement.
Outlines PLC input/output states for single pushbutton operation.
Describes PLC input/output indications when the reset loop is used to close the gate.
Explains PLC input/output behavior for the latching keyswitch operation.
General| Brand | GpsGate |
|---|---|
| Model | GPS1195 |
| Category | Fencing & Gates |
| Language | English |
To Next Page