Grace M905 - Page 31

To Next Page

To Previous Page

For PC, the input stream format is selected in the USB Audio Driver Control panel as shown:

Note: If your application does not require more than 2 input channels, the 2 input/2output setting is recom-

mended as it requires less over all bandwidth of the USB connection.

Main Page

1 Welcome2
- Table of Contents2
2 Important Safety Information3
3 Safety Marking Symbols3
4 Service Information3
5 M905 Features4
- M905 Audio Control Unit Rear Panel5
- Audio Control Unit Front Panel6
- Remote Control Unit (RCU)6
- M905 Graphical User Interface7
7 Unpacking and Installing8
- Your M905 Box will Contain8
- Open and Inspect the Box8
- Register Your Unit8
8 Connecting the M9058
- Power Connections8
- Power-Up Sequence9
- System Connections9
9 Normal Operation Mode11
- Input Selection11
- Volume Control, Preset & Headphone Mute12
- Speaker Output Selection12
- Monitoring Option Controls12
- Display15
- Save / Recall of User Configuration15
- Optional IR (Infrared) Remote Control Operation15
- Analog Only Option17
- Phono Module Option17
10 Setup Mode17
- Entering and Exiting Setup Mode17
- Input Setup18
- Speaker Setup20
- DIM Setup22
- SUB / DAC / METER Setup22
- CUE Output Setup23
- Headphone Setup23
- Talkback Setup24
- Mute / (Solo)25
11 General Setup25
- Display Setup26
- IR (Infrared) Remote Setup26
- DIGI LOOP Setup27
- Digital Input Setup27
- System Setup27
- SPL Meter Setup28
12 About Crossfeed28
13 Communication Error Handling29
14 Computer Audio Setup30
- Asynchronous USB Audio30
- USB up Channel Setup30
- Computer Audio Requirements32
- Using the M905 for DAW Playback32
15 Updating Firmware32
- Updating RCU Firmware33
- Updating ACU Firmware34
- Updating XMOS Firmware35
16 Specifications37
17 Block Diagram39
18 Pcb Jumper Locations40
- Wiring Diagrams42
20 Cleaning and Maintenance43
21 Warranty Information43
22 Manual Revisions44

Grace M905 - Page 31

Table of Contents

Related product manuals