EasyManuals Logo

Graco 254986 User Manual

Graco 254986
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Mixing Material
10 311764D
Mixing Material
Dry Mix - 40 lb (18 kg) bag
1. Carefully mix texture material and water according
to manufacturer instructions on bag.
2. Agitate to mix, using a half-inch, variable speed drill
with mixing paddle, to a smooth, lump-free consis-
tency.
3. Allow ceiling texture to set for at least 15 minutes.
Then remix prior to use.
4. After texture material is thoroughly mixed, gently set
ball end of Material Thickness Gauge on surface of
mixture.
5. Observe the ball on the material. When the material
is thin enough to spray the ball will sink completely
into the mixture.
6. If the ball does not sink completely into the mixture
within 10 seconds, add more water, agitate and try
test again.
Premix
1. Slowly add approximately 2 to 4 qts (1.9 to 3.8 liters)
of water to a 5 gallon (18.9 liter) bucket of premix.
2. Agitate to mix, using a half-inch, variable speed drill
with a mixing paddle, to a smooth, lump-free consis-
tency.
3. After texture material is thoroughly mixed, gently set
ball end of Material Thickness Gauge on surface of
mixture.
4. Observe the ball in material. When the material is
thin enough to spray the ball will sink completely into
the mixture.
5. If the ball does not sink completely into the mixture
within 10 seconds, add more water, agitate and try
test again.
Correct material mixture is essential. The pump
will not operate if the mixture is too thick.
Mix the material in a separate container before
pouring it into hopper.
Use Material Thickness Gauge to determine mix-
ture is thin enough to spray.
*The Material Thickness Gauge will only deter-
mine if the material is thin enough to pass through
the pump. For some applications or for higher
speed spraying, your mixture may need to be thin-
ner.
For best results do not use partial bags of mate-
rial.
For an accurate test, be sure gauge is completely
dry and clean every time it is used.
TI
ti2496a
ti2497a
For an accurate test, be sure gauge is completely
dry and clean every time it is used.
ADD WATER
READY
ti2498a
ti2493a
ADD WATER
READY
ti2498a

Other manuals for Graco 254986

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Graco 254986 and is the answer not in the manual?

Graco 254986 Specifications

General IconGeneral
BrandGraco
Model254986
CategoryPaint Sprayer
LanguageEnglish

Related product manuals