Setup
311764D 7
Setup
Texture Spraying (material supplied from
unit)
1. Connect air hose and material hose to sprayer air
and material hose outlets.
2. Connect air hose to gun.
3. Open gun air valve.
4. Connect material hose to gun.
5. Install spray nozzle. See Recommended Nozzle
Selection Chart, Page 11.
6. Fill material hopper with 1 gallon of water.
7. Turn selector knob to SPRAYER (this acts a flow
control on TX 125 models).
Important
• To increase pump life, turn power off when not spraying.
• Do not allow material to dry inside pump, hoses, gun or spray system.
When using material
supplied from unit,
insert the Gun Plug in
the top of the gun.
Hose plug must be
removed from bottom
of gun.
ti8701a
ti8698a
ti8534a
ti8528a
ti8705a
ti8706a
ti8700a
ti8729a
To Next Page
Loading...
Need help?
General
