Setup
8 311764D
8. Turn power switch ON.
9. Close gun air valve.
10. Point gun into waste bucket and pull trigger to pump
water through the system. Continue to trigger gun
until material hopper is empty.
11. Make sure burp guard is installed, Caution, page 3.
12. Add pre-mixed texture mix to material hopper. See
Mixing Material, page 10.
13. Continue to trigger gun and spray into waste bucket
until a steady stream of material sprays out of gun.
14. Open gun air valve.
15. Release trigger. To achieve uniform spray pattern,
adjust air valve and flow adjustment nut on gun (or
use Material Flow Control knob on 125 models). If
you do not achieve the desired pattern, change noz-
zles, page 11.
ti8711a
ti8712a
ti9274a
ti8703a
Fluid flow will be restricted if the material hose is
kinked.
ti8528a
ti8532a
To Next Page
Loading...
Need help?
General
