Pressure Relief Procedure
10 3A4967C
Pressure Relief Procedure
Follow the Pressure Relief
Procedure whenever you see this
symbol.
1. Turn the ON/OFF switch to OFF
position.
Standard Models:
ProContractor and ProComp Models:
2. Unplug power cord to disconnect power.
3. Disconnect spray gun from air hose.
If using a FlexLiner System:
4. Disconnect tubing from gun to relieve
pressure in the cup.
If using a ProComp remote cup:
5. Turn compressor ON/OFF switch to OFF
position.
6. Disconnect air hose from remote cup.
Turn out pressure regulator one turn.
Wait until pressure is completely
relieved before removing cover.
The spray gun cup is pressurized. To
reduce the risk of splashing from
pressurized fluid, always follow the
Pressure Relief Procedure before
removing cup.
ti30756a
ti30625a
ti30756a
ti30757a
To Next Page
Loading...
Need help?
General
