Graco HVLP EDGE II User Manual

3A4980B
EN
Operation/Repair/Parts
HVLP EDGE II
™
/EDGE II Plus Gun
For the application of architectural paints and coatings. The HVLP Edge II Gun is not
intended to be used on an external compressor. For professional use only.
Models: 17P481, 17P483, 17P484, 17P653, 17P654
10 psi (0.07 MPa, 0.7 bar) Maximum Air Working Pressure
50 psi (0.35 MPa, 3.5 bar) Maximum Fluid Working Pressure
Important Safety Instructions
Read all warnings and instructions in this manual and your sprayer instruction
manual. Be familiar with the controls and the proper usage of the equipment.
Save these instructions.
Related Manuals:
3A4967 Graco FinishPro
HVLP Sprayer
ti30935a
www.graco.com/techsupport
?? ??

Graco HVLP EDGE II Specifications

General

Type	HVLP (High Volume Low Pressure)
Power Source	Electric
Voltage	120V
Cup Size	20 oz
Container Size	20 oz

Summary

Models

Key Features

Details the main advantages of the Edge II and Edge II Plus spray guns.

Warnings and Safety

Fire and Explosion Hazards

Specific warnings related to flammable materials and ignition sources.

Pressurized Equipment Hazards

Warnings concerning fluid pressure and potential injury.

Equipment Misuse Hazards

Pressurized Aluminum Parts Hazards

Toxic Fluid or Fumes Hazards

Personal Protective Equipment Recommendations

Know Your Spray Gun - EDGE II

EDGE II Component Identification

Know Your Spray Gun - EDGE II Plus

EDGE II Plus Component Identification

Pressure Relief Procedure

Setup Procedures

Fluid and Work Piece Preparation

Fluid Set Selection Guide

Startup - Fill FlexLiner System

Startup - Fill Siphon Cup

How to Spray

Adjust Spray Pattern

Adjust Flow and Pattern Size (EDGE II)

Adjust Flow and Pattern Size (EDGE II Plus)

Cleanup Procedures

Troubleshooting Common Issues

Orange Peel Finish

Solutions for a rough, orange peel-like paint surface.

Blushing Clear Coatings

Fish Eyes on Surface

Runs and Sags in Paint

Troubleshooting Solvent Pops and Bubbles

Troubleshooting Fluid Flow Issues

Troubleshooting Fluid Leaks

Troubleshooting Poor Spray Pattern

Troubleshooting Packing Nut Leaks

Troubleshooting Needle Return Issues

Troubleshooting FlexLiner System Problems

Technical Specifications

EDGE II / EDGE II Plus Specifications

Detailed technical data for both models.