Clamp
NOTE:
A standard steering wheel puller is required to
remove the clamp. T
wo 1/4–28 x 3 or 4 in. long screws
are also needed.
NOTE:
Refer to Fig. 27.
1.
Loosen the two screws (16) on the clamp (3),
working through the slot at the bottom of the clutch
housing (2).
2.
Install two screws (B) of the tool (A) in two of the
threaded holes in the clamp. T
ighten the screws
(C) until the clamp comes of
f.
3.
Skip ahead to
Reassembly
,
page 28, Step 3, or
continue to the right.
Fig. 27
2
3
16
B
C
A
Torque
to 125 in–lb (14 N.m)
Clutch
Housing
NOTE: Refer
to Fig. 28.
1.
Remove the four capscrews (8) and lockwashers
(48) which hold the clutch housing (2) to the en
-
gine (1).
2.
Remove the engine key (13).
3.
Pull of
f the clutch housing (2).
4.
Skip ahead to
Reassembly
,
page 28, Step 1, or
continue on page 30.
Fig. 28
13
2
8
48
1
0156
To Next Page
Loading...
