Graco GX21 User Manual

Operation
3A8429B 19
Fill Gun and Hose
1. Hold gun against waste pail. Point gun
into waste pail.
a. Disengage trigger lock.
b. Pull and hold gun trigger.
c. Turn Prime/Spray valve to SPRAY
position.
d. Press ON/OFF switch to ON posi-
tion. Button is illuminated when
power is ON.
2. Trigger gun into waste pail until only
paint comes out of the gun.
3. Release trigger. Engage trigger lock.
4. Transfer drain tube to paint pail and clip
to suction tube. On hopper models, clip
drain tube to hopper.
NOTE: When motor stops sprayer is ready
to paint. If motor continues to run sprayer is
not properly primed, repeat Fill Pump and
Fill Gun and Hose.
ti27139a

Graco GX21 Specifications

General

Maximum Operating Pressure	3300 psi
Hose Length	50 ft
Power Source	Electric
Max. Working Pressure	3300 psi
Type	Airless Paint Sprayer
Voltage	120V
Maximum Tip Size	0.021 inch
Motor	DC Motor
Flow Rate	0.31 GPM
Tip Size	0.021 in