Appendix B - ADM Setup Screens Overview
56 3A2797ZAA
5. Enter the calculated value in the ∆ column.
Shot Calibration Table
This screen allows the user to set the offset, ∆(g), for a
calculated range of shot sizes based on pump sizes
and material specific gravity.
NOTE: This table is only available when defining the
shot by weight.
To enable the shot calibration table:
1. Navigate to Advanced Screen 4.
2. Press then use the arrow keys to navigate to
the “Enable Range Calibration” option.
3. Press to activate the option.
To edit a shot definition:
1. Navigate to Shots Screen.
2. Press to enter the screen.
3. Press to show the shot calibration table.
4. Press then use the arrow keys to navigate to
the desired value.
5. Type the new value then press to accept the
new value.
6. Repeat as required for other ranges.
Example 3:
To Next Page
Loading...
