EasyManuals Logo

Graco HVLP EDGE II Plus Operation, Parts

Graco HVLP EDGE II Plus
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Setup
3A5097C 9
Setup
Fluid and Work Piece
Preparation
Strain fluids before spraying. This
includes colors, reducers and
hardeners.
Use a slower drying reducer or thinner to
compensate for the faster drying time
caused by the warm air of the turbine. Do
not over reduce.
Spray performance varies with the
viscosity of the material sprayed, HVLP
sprayer, and length of hose.
Most material manufacturers provide
recommendations for their materials.
Follow these recommendations.
For proper adhesion, ensure surface of
work piece is completely clean.
Fluid Set Selection
For best spray performance, select proper
fluid set for fluid being sprayed. Reference
the Fluid Set Selection Guide for the fluid
set recommended for your application. Fluid
set numbers are marked on fluid needles and
nozzles.
FLUID SET SELECTION GUIDE
Material Fluid Set #2 Fluid Set #3 Fluid Set #4 Fluid Set #5 Fluid Set #6 Fluid Set #7
17P485 17P486 17P487 17P488 17P489 17P490
Dye
Ink
Non-wiping Stain
Automotive Finish
Lacquer
Stain
Enamel
Epoxy
Urethane
Varnish
Primer
Industrial Finishes
Latex
Multi-Spec
Butyrate
Nitrate Dope
Oil Wall Paint
ti30938a

Other manuals for Graco HVLP EDGE II Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Graco HVLP EDGE II Plus and is the answer not in the manual?

Graco HVLP EDGE II Plus Specifications

General IconGeneral
BrandGraco
ModelHVLP EDGE II Plus
CategoryPaint Sprayer
LanguageEnglish

Related product manuals