Graco LineLazer IV 5900 - Page 19

Digital Tracking System (DTS)
311017A 19
4 Short press DTS button to
move to Job Distance (ft or
m).
Note: Displays the linear line
length applied since the last
reset. See Reset screen, step
9.
5 Short press DTS button to
move to Job Material
Counter.
Note: Displays material
sprayed (gallons or liters x 10)
since the last reset.
6 Short press DTS button to
move to Line Width (LW)
Selector.
Note: Displays the line width
used to calculate film build (in.
or cm).
7 Press and hold DTS
button to change LW. LW
changes from 2 - 12 in. (5 -
30 cm). Release DTS
button when desired LW
appears.
Note: If your distance reading
is feet, LW is inches. If your dis-
tance reading is meters, LW is
centimeters.
WLD
WLD
WLD
WLD