Graco LineLazer IV 5900 - Page 23

Digital Tracking System (DTS)
311017A 23
8 To use MEASure mode,
press and hold DTS
button until distance
display appears.
Note: To skip MEASure
mode, short press DTS
button, to go to step 9.
a Short press DTS again to
start measuring.
ON appears on left side of
display. Now push striper
and measured distance
appears in display.
b Short press DTS again to
stop measuring.
Note: Repeated short presses
of DTS alternately turn
MEASure mode on and off.
c Press and hold DTS
button to reset to zero.
WLD
WLD
WLD
WLD