Graco LineLazer IV 5900 - Trigger Sensor Adjustment; Adjusting Trigger Sensitivity

Digital Tracking System (DTS)
28 311017A
Change Display Units
Pressure:
From Pressure display only,
press and hold (8 seconds)
DTS button to change pressure
units (psi, bar, MPa), to desired
units.
Volume:
From Job Material Counter dis-
play only, press and hold (8
seconds) DTS button to change
volume units (GAL, LITER10).
Distance:
From Job Distance Counter dis-
play only, press and hold (8
seconds) DTS button to change
distance units (ft or m).
Note: This also changes film
build (mils or microns), line
width (in or cm) and speed
(mph or kph).
WLD
PSI
"AR
MPA
PSI
"AR
MPA
WLD
*$/
/,7(5;
WLD
IW
P