Getting Started With Basic Techniques
313034H 17
Getting Started With Basic Techniques
Use a piece of scrap cardboard to practice these basic
spraying techniques before you begin spraying the sur-
face.
• Hold gun 12 in. (30 cm) from surface and aim
straight at surface. Tilting gun to direct spray angle
causes an uneven finish.
• Flex wrist to keep gun pointed straight. Fanning gun
to direct spray at angle causes uneven finish.
Triggering Gun
Pull trigger after starting stroke. Release trigger before
end of stroke. Gun must be moving when trigger is
pulled and released.
Aiming Gun
Aim tip of gun at bottom edge of previous stroke, over-
lapping each stroke by half.
12 in.
(30 cm)
even
finish
thick
thin
uneven
finish
ti5585a
even finish thin thick thin
ti2036a
ti2037a
ti2038a
To Next Page
Loading...
