Grounding
8 3A2244A
Grounding
The sprayer cord includes a grounding wire with an appropri-
ate grounding contact.
This sprayer requires 220-240 VAC, 50/60 Hz circuit with a
grounding receptacle. Never use an outlet that is not
grounded.
Do not modify plug! Tampering with the plug will result in a
voided warranty. Do not use sprayer if electrical cord has dam-
aged ground prong.
If plug will not fit in outlet, have grounded outlet installed by a
qualified electrician. Do not use an adapter. NOTE: Smaller
gauge or longer extension cords may reduce sprayer perfor-
mance.
Pails
Do not place pail on a nonconductive surface such as paper or
cardboard which interrupts grounding continuity.
Grounding a metal pail: connect a ground wire to the pail by
clamping one end to pail and other end to a true earth ground.
To maintain grounding continuity when flushing or
relieving pressure: hold metal part of spray gun firmly to side
of a grounded metal pail. Then trigger gun.
Thermal Overload
Motor has a thermal overload switch to shut itself down if over-
heated. If unit overheats, allow approximately 45 minutes for
unit to cool. Once cool, switch will close and unit will restart.
The equipment must be grounded to reduce the risk of static
sparking and electric shock. Electric or static sparking can
cause fumes to ignite or explode. Improper grounding can
cause electric shock. Grounding provides an escape wire for
the electric current.
To reduce the risk of static sparking, explosion and elec-
tric shock when using solvent and oil/based fluids, use
only conductive metal pails, placed on a grounded surface
such as concrete.
ti7528b
To reduce risk of injury from motor starting unexpectedly
when it cools, always turn power switch OFF if motor shuts
down.
ti5850b
ti14840a
ti18247a
To Next Page
Loading...
Need help?
General
