98
Sliding Latch Plate and ALR Retractor
A latch plate that slides freely on the belt
webbing and cannot, by itself, hold the
belt snug around a car seat.
Slowly pull the shoulder belt all the
way out. Route the vehicle seat belt
through the proper belt path and buckle
it in. Then, as you pull the vehicle seat
belt tight, feed all the slack back into the
retractor.
Grab the sides of the seat at the belt path
and slide the seat side-to-side and front-
to-back. The seat should not move more
than 2.5 cm (1”).
Note: If using the lock-off, you do not need to
switch the retractor.
To Next Page
Loading...
Need help?
General
