Before Installi
ng
Location
When selectin
g a location, make sure the location:
• Is close to where the fluid is being delivered to
minimize back pressure and maximize flow rate.
• Provides enough room around the equipment for
maintenance.
• Does not interfere with opening the control panel
door or frame door (on one or both sides).
• Provides enough room on the right and/or left side
of the SaniForce STU to easily load and unload
fluid totes with a forklift or pallet jack hand truck.
• Provides easy and safe access to the air supply
shutoff valves and the control panel. Graco
recommends a minimum of 3 ft (0.91 m) of open
space in front of the panel.
• Provides enough overhead clearance (10 ft, 2.7 m
recommended) for installing and servicing the STU.
• Has a flat, level floor, or level pads.
Moving Frame to Location
The frame is shipped with several major
components attached and weighs about 1500 lb.
(680 kg). To avoid injury and equipment damage,
follow instructions below.
The STU must be firmly attached to the floor. The
STU is capable of exerting downward force of 2220
lbf (9.9 kN) which could cause the STU to lift off of
the floor during operation.
• Use a forklift or hand truck and support devices,
such as a hoist, and have an adequate number of
personnel to move the frame to the installation site.
• Avoid jarring or tilting the frame while moving it.
• When the fully assembled unit has been moved to
the installation location:
–Markthel
ocation of the mounting foot holes on
the floor.
–Movethef
rame out of position by rotating it to
the side
.
– Drill an
chor mounting holes and insert anchors
at all ma
rked foot hole locations.
– Rotate t
he frame back into position and install
frame m
ounting bolts through frame feet.
3A5416C 13
To Next Page
Loading...
