Graco Reactor 2 Series User Manual

Operation
Reactor® 2 Elite Integrated
Proportioning System
332636C
EN
Electric, Heated, Integrated Plural Component Proportioning System With Integrated Generator. For
spraying polyurethane foam and polyurea coatings. For professional use only. Not approved for use in
explosive atmospheres or hazardous locations. Not for outdoor use.
Important Safety Instructions. Read all warnings and instructions in
this manual. Save these instructions.
PROVEN QUALITY. LEADING TECHNOLOGY.

Graco Reactor 2 Series Specifications

General

Brand	Graco
Model	Reactor 2 Series
Category	Water Pump
Language	English

Summary

Warnings and Safety Precautions

General Safety Warnings

Covers electric shock, toxic fluids, CO, PPE, skin injection, fire, thermal, pressurized parts, and misuse hazards.

System Setup Procedures

Locating and Preparing the Reactor

Instructions on positioning the Reactor and preparing the environment for setup.

Connecting Battery and Adding Fuel

Steps for safely connecting the battery and filling the fuel tank.

Grounding Procedures

Essential steps for proper system grounding to prevent static and electrical hazards.

System Operation

Initial System Setup and Configuration

Tasks to perform for the initial setup and configuration of the system.

Run Mode and Target Settings

Operating modes, system status display, and setting target temperatures and pressures.

System Startup Procedures

Pre-Startup Checks

Essential checks before starting the generator and system.

Engine Start and Initial Setup

Spraying Procedures

System Preparation for Spraying

Spray Adjustments and Testing

System Shutdown Procedures

Immediate and Daily Shutdown Steps

Pressure Relief Procedure

Safely Relieving System Pressure

System Error Management

Understanding and Identifying Errors

Troubleshooting and Clearing Errors

Maintenance Procedures

Preventative Maintenance Schedule and Checks

Engine, Compressor, and Dryer Maintenance